Denim that stays damp through two full cycles, a drum that squeals as it turns or a dryer that ignores the start button entirely? We send someone to your Lewisville home who tests gas and electric models on the spot and gets laundry coming out warm and dry again.
Gas and electric models wear out along the same lines. Here are six symptoms homeowners describe on the phone, matched with the parts our techs look at early.
Inspection sheet
Clothes keep tumbling yet stay cold because a heating element burned through, a gas igniter weakened or a safety fuse opened.
Clothes need extra time because the moisture sensor misreads, a cycling thermostat sticks or the element only heats part of the way.
The motor hums or runs while the drum sits still, which usually means the belt snapped or the idler pulley seized.
Flat-spotted rollers, a parched rear bearing and worn glides make every load sound like trouble.
Silence and a dark panel can point to a faulty door switch, a dead start switch or a blown thermal fuse.
The dryer quits before the timer ends when the motor overheats or a temperature sensor sends a false reading.
Dryers we repair
Speed Queen and Frigidaire dryers flash these codes when something interrupts a cycle. Here is which ones you can handle and which need us.
Speed Queen
The control sensed no drum movement. Remove anything jammed in the drum, press a key to clear the code and restart.
Cut power at the breaker, restore it and try the cycle again. A repeat means a board or harness needs service.
The control sees an open circuit on the heat sensor, so the thermistor, its wiring or the output board needs replacing.
The control cannot read the door input, and the output board must be replaced.
Frigidaire
A key is stuck or was held down too long. Press each one gently to free it, then restart the dryer.
Unplug the dryer for a few minutes and start a new cycle. If E10 returns, the control board needs replacing.
The control thermistor or its wiring is open, so the dryer cannot track temperature until parts are tested and replaced.
The temperature never climbs, pointing to a failed heater circuit, relay or control board.
See a code that isn't here, or one that comes right back? Phone our office and we'll schedule a technician.
Lewisville customers on their dryer repair.
Running every towel load twice was costing us a fortune. He tested it, swapped what was worn out and now one round does the job.
That squeal could wake the whole house. Gone.
Pressed start and got nothing, not even a hum. I figured the dryer was finished. He tracked it down in no time and explained what tripped it so I know what to watch for.
Run through these four checks when your dryer misbehaves. One of them might sort it out.
Leave these to us
Each of these repairs comes with a 90-day warranty on parts and labor.
Clothes still damp?
Beyond these checks, the job is for certified and insured technicians.
Pop your name and number into the clipboard. Our Lewisville office phones you to pick a visit time that fits your week.
Rather talk it through?
Service request
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.